Use the data in the following table to use the Port AutoSense tab.

View or Modify the Auto-sense Port Configuration

Perform this procedure to view or modify the Auto-sense configuration on one or more ports. You also have the option to disable Auto-sense on the port but retain the configuration that the system applied dynamically. The dynamic configuration becomes a manual configuration and is visible in the show running-config output.

Procedure

  1. In the navigation pane, expand Configuration > Fabric.
  2. Select AutoSense.
  3. Select the Port AutoSense tab.
  4. To change the Auto-sense state on a port, select a new value for AutoSense in the appropriate row for the port.
  5. Optional: If you disable Auto-sense on a port, select true for AutoSenseKeepAutoConfig to retain the configuration that the system applies dynamically.
  6. Optional: Type a value in AutoSenseDataIsid to configure a specific I-SID on the port.
  7. Optional: Type a value in AutoSenseWaitInterval to configure a specific interval on the port.
  8. Select Apply.

Port AutoSense Field Descriptions

Use the data in the following table to use the Port AutoSense tab.

Name Description

Index

Displays the index of the port, written in the slot/port[/sub-port] format.

AutoSense

Enables or disables Auto-sense on the specific port. The default value is disabled for existing configurations but enabled for new Zero Touch Fabric Configuration deployments.

AutoSenseKeepAutoConfig

Retains the Auto-sense configuration if you disable Auto-sense on the port. The dynamic configuration becomes a manual configuration and is visible in the show running-config output.

AutoSenseState

Displays the Auto-sense port state.

AutoSenseDataIsid

Specifies the Auto-sense data I-SID per port. The port configuration takes precedence over the global data I-SID configuration.

AutoSenseWaitInterval

Specifies the Auto-sense wait time on a port. The port configuration takes precedence over the global wait-interval configuration. The default value is 35.